Terminal lugs are little metal helpers for connecting two wires together. Like little connectors that hold wires in place. They are super important for any electrical work as they keep your connections secure and safe. Recently developed terminal lugs, which let you attach a wire to the connector, were a solution, but wires could still become loose. In this case crimping terminal lugs means using a special tool to clamp the lug tightly down onto a wire. This squeezing creates a strong stitch that holds the wires together. It is better than just twisting the wires together, which might not be safe and also might not hold as well.
To crimp terminal lugs like a pro, though, you need a few tools. The first tool you need is wire stripper. These Dingcheng copper crimping lugs also allow you to remove the plastic from the end of the wire. You want to strip just the right amount, enough for the wire to be exposed, but not too much. Then you will need a crimping tool. It is a special tool which makes the lug squeeze tightly to the wire. When crimping, putting the lug in the crimping tool correctly before squeezing it shut is a must. This is a very critical step to ensure the lug is secured to the wire.
Crimping terminal lugs might be one of the most important aspects of ensuring your electrical connections are safe and reliable. If a lug is not crimped properly, it may come loose. That could lead to a short circuit, electricity traveling the wrong way, or other electrical issues. These problems can be extremely dangerous. They can damage your equipment or, in the worst-case scenario, even cause a fire. If you crimp your terminal lugs in the proper way, you can prevent putting yourself at risk for any of these hazards. Knowing that your connections are strong and secure will make you feel less anxious.
The right size lug for the wire type is a common mistake made when crimping terminal lugs. So the size of the lug needs to be matched with the size of the wire. The Dingcheng cable lug 25mm must be just right, though -- if it is either too large or too small, it will not fit and will likely not form a strong connection. Another error is failing to remove enough insulation from the wire prior to crimping the lug on. You have to ensure that you remove enough insulation so the lug has a solid connection to the wire. If not enough get away, the connection is not strong enough.
You begin by stripping half an inch of plastic from the wire using a wire stripper. Make sure you cut the outer layer and not the wire itself.
The next step is to insert the bare end of the wire into the lug. Push it until you hit the stop on the inside lug. This makes sure that it is properly placed
Finally, pull on the Dingcheng cable jointer lug a bit to ensure that it is attached snugly on the wire. Having this additional step helps ensure that everything is done right.
Copyright © Renqiu Dingcheng Electric Power Equipment Manufacturing Co.,Ltd All Rights Reserved
EN
